Replication reaches 100% but then seems to freeze at this mark
Challenge
Replication reaches 100% but then seems to be stuck in Acura Control Panel.
Cause
When the status of a machine in ACP is
Replicating(100%) from the backend point of view, it means that the backup process is complete and a snapshot is being created in the target cloud. The delay is temporary and will take as much time as needed by the cloud to create the resource. The progress can be tracked in the target cloud if necessary.
Related Articles
How to allow a machine to be discovered in ACP after a failback to VMware
Challenge A machine is not listed in ACP after performing a failback to VMware. Cause By design, a failback machine in VMware is marked with a flag that blocks it from being rediscovered in ACP right after the process has been completed. This helps ...How to stop replicating a machine
Task Stop replicating a machine Solution Park the machine to stop its replication. On the Customer page in the “Machines Groups” section click on the “…” button next to the corresponding machine, select “Park”.How to specify Volume availability zone and Volume type when replicating a machine
Challenge Replication settings for machine's volumes require specific parameters. Solution Before the first replication is initiated, two additional parameters can be specified for each machine: Volume availability zone and Volume type. Click on ...Target datastore and host are not shown in ACP at the last step of the failback wizard
Challenge Generally, a target datastore and host are not shown in ACP if a Failback Agent does not have proper network configuration and therefore has no connection to VMware or to Acura, which it constantly sends heartbeats to. Solution Please make ...How to pause all replications for a customer
Task You need to pause all replications for a customer Solution Go to Edit of the customer Uncheck Active checkbox. No snapshots will be removed, replication will be just paused.